**IMPORTANT! PLEASE READ!**

You are viewing a second quality item. Each piece is perfectly wearable/usable with minor stitching flaws, uneven stitching, buttons in an incorrect position, etc. Seconds are not returnable or exchangeable...

PLEASE NOTE: WE WILL NOT BE OFFERING HEMMING ON SECONDS GUTHRIES.

These have been in the works for YEARS and we're very excited to finally release them into the wild! These are our endgame heavyweight work pants: 18oz Dry Waxed Cotton Twill doubled up in the thighs, knees and the seat for hard wear and tool pockets you can actually get your hands (and cell phone) into, these are made to take a BEATING. This is the same base fabric as our Wills Jacket but with a dry wax finish... These have been pre-washed to remove shrinkage and soften them up out of the gate.

The fit is a straight leg that'll fit over your engineer boots perfectly and a top block we brought over from the Holcomb Jeans. Not too tight and not too loose. Please compare measurements below to a pair of jeans you currently own.

A note on fit: These pants are THICK... If you're in between sizes or like a little more room, definitely err on sizing up rather than down.

Details

• Made In USA

• 18oz Dry Wax Cotton Twill - Made in Scotland by Halley Stevenson

• Front Pockets Lined in Amber Bedford Corduroy

• Material Doubled Up In High Wear Areas

• Solid Brass Donut Buttons with Two Prong Copper Tacks

Care

These pants have been prewashed and should not shrink if laundered according to the care instructions (Cold Wash, Hang Dry, Low Iron).

Sizing

SIZE 28 30 31 32 33 34 36 38 40

WAIST 14.50 15.50 16.00 16.50 17.00 17.50 18.50 19.50 20.50

SEAT 17.75

19.25

19.75 20.50 21.50 21.50 22.50 23.25 24.25

THIGH 10.25 10.75 11.00 11.25 11.50

11.75

12.50

13.00

13.25

BOTTOM HEM 7.50

7.50 7.75 7.75 8.00 8.00 8.25

8.50

8.75

FRONT RISE 11.00 11.00 11.25

11.50 11.50 11.75 12.00

12.50 12.75