3D printed Slide Reel from Outer Wilds 🪐 It is 11cm height and has a diameter of 26cm. The big support has a 31cm diameter and it is around 28cm height with the lantern in the middle. The branches support is 24cm height and 37cm wide and its full height with a Slide Reel on it is 38.5cm.

🖼️ I will put the slides on the front and back depending on your order, with the big support with the green lantern inside, I only put the front one to reduce the thickness and allow the lantern to properly enlight the slide facing the hole. If you order a Slide Reel alone or with the branches support I will also put the back one mirrored. You can contact me if you want me to handle them differently.

📩 Also feel free to DM me after your order to tell me which slides you wish inside your reel. Without message I will put inside the one in the photos or from this tweet. You can contact me if you want some others (full list here).

Note the inner silver rings are not glued and can be removed so you can change the pictures inside. You can print some yourself (I print it on some glossy paper and the pictures diameter is ~87mm) and I can help you make the template you can print afterwards.